Extreme Networks NX-7510-100R0-WR网络管理设备
1.产 品 资 料 介 绍：
- NX-7500 系列核心适配：Extreme Networks NX-7510-100R0-WR 作为高阶网络管理设备，专为 NX-7500 系列核心交换机设计，通过专用业务插槽安装，可无缝扩展主机广域网接入与管理能力，相比 NX-5500 系列适配机型，支持更高端口密度与带宽等级，适配超大型企业总部、区域数据中心核心层场景。
- 万兆级广域网端口配置：基于 “WR” 标识强化广域网适配，配备多组 SFP+/QSFP28 端口组合（推测含 4-8 个万兆 / 40G 端口），支持千兆至 40Gbps 速率灵活切换，兼容专线、SD-WAN 等广域网接入方式，满足总部与多分支机构、跨区域数据中心的高速互联需求，带宽能力较 NX-5500 系列模块提升 2-4 倍。
- 超高性能转发架构：采用新一代非阻塞交换芯片，交换容量预计达 400Gbps 以上，转发速率超 296Mpps，支持 64Byte 小包线速处理，配合 NX-7500 系列主机的高性能背板，可承载大规模虚拟化业务、跨区域云互联等高负载流量，延迟控制在微秒级，适配核心层低延迟传输需求。
- 长距广域网传输优化：SFP+/QSFP28 端口支持超远距离光模块（如 1550nm 单模光纤模块，传输距离达 100km 以上），内置广域网信号放大与纠错机制，可直接实现跨城市、跨区域广域网直连，无需额外部署中继设备，降低长距互联成本，相比 NX-5500 系列模块传输能力显著增强。
- SD-WAN 与广域网协议深度融合：除兼容 BGP、OSPF、MPLS VPN 等传统协议外，新增 SD-WAN 智能路由功能，支持基于带宽、时延、成本的动态路径选择，可自动优化跨区域业务流量路径；同时原生支持 IPv4/IPv6 双栈与 Segment Routing，满足下一代广域网协议升级需求，适配企业数字化转型中的网络架构演进。
- 多模块冗余与集群扩展：支持最多 8 个同型号模块组建冗余集群，通过链路聚合（LAG）与冗余路由协议（如 VRRP）实现多路径备份，单点模块故障时业务自动切换，切换时间小于 50ms；配合 NX-7500 系列主机的堆叠功能，可构建超大规模核心层广域网接入集群，扩展能力较 NX-5500 系列提升 1 倍。
Extreme Networks NX-7510-100R0-WR网络管理设备 英文资料：
NX-7500 Series Core Adaptation: The Extreme Networks NX-7510-100R0-WR, as a high-level network management device, is designed specifically for NX-7500 series core switches. It is installed through dedicated business slots and can seamlessly expand host wide area network access and management capabilities. Compared to the NX-5500 series adaptation models, it supports higher port density and bandwidth levels, and is suitable for core layer scenarios of ultra large enterprise headquarters and regional data centers.
10 Gigabit Wide Area Network Port Configuration: Based on the "WR" identification, it strengthens the wide area network adaptation and is equipped with multiple sets of SFP+/QSFP28 port combinations (presumably including 4-8 10 Gigabit/40G ports), supporting flexible switching of gigabit to 40Gbps rates, compatible with dedicated lines, SD-WAN and other wide area network access methods, meeting the high-speed interconnection needs of headquarters, multi branch offices, and cross regional data centers. Its bandwidth capacity is 2-4 times higher than that of NX-5500 series modules.
Ultra high performance forwarding architecture: adopting a new generation of non blocking switching chips, the expected switching capacity is over 400Gbps, the forwarding rate is over 296Mbps, supporting 64Byte small packet line speed processing, and coupled with the high-performance backplane of NX-7500 series hosts, it can carry high load traffic such as large-scale virtualization services and cross regional cloud interconnection, with latency controlled at the microsecond level, adapting to the low latency transmission requirements of the core layer.
Long distance wide area network transmission optimization: SFP+/QSFP28 ports support ultra long distance optical modules (such as 1550nm single-mode fiber modules, with a transmission distance of over 100km), built-in wide area network signal amplification and error correction mechanisms, which can directly achieve cross city and cross regional wide area network connection without the need for additional relay devices, reducing long-distance interconnection costs. Compared with NX-5500 series modules, the transmission capacity is significantly enhanced.
Deep integration of SD-WAN and WAN protocols: In addition to being compatible with traditional protocols such as BGP, OSPF, MPLS VPN, etc., SD-WAN intelligent routing function has been added, supporting dynamic path selection based on bandwidth, latency, and cost, which can automatically optimize cross regional business traffic paths; At the same time, it natively supports IPv4/IPv6 dual stack and Segment Routing, meeting the needs of next-generation wide area network protocol upgrades and adapting to the network architecture evolution in enterprise digital transformation.
Multi module redundancy and cluster expansion: Supports up to 8 modules of the same model to form a redundant cluster, and achieves multi-path backup through link aggregation (LAG) and redundant routing protocols (such as VRRP). When a single module fails, the business automatically switches, with a switching time of less than 50ms. Combined with the stacking function of NX-7500 series hosts, it can build a large-scale core layer wide area network access cluster, with expansion capabilities twice as high as NX-5500 series.
Extreme Networks NX-7510-100R0-WR网络管理设备 产品展示
产品视频
3.其他产品
FOXBORO P0926GV FBM231 冗余通信模块
IC695CPE400-ABAB 以太网端口模块
TRICONEX DI3301 数字输入模块
4.其他英文产品
B&R 5AP920.1505-01 Touch Pad Module
B&R 5AP1151.0573-000 Operation Panel
B&R 5AP1120.0573-C04 Industrial Display Module
| AMAT 0190-07274 | AMAT 0190-35463 | AMAT 0190-28556 |
| AMAT 0190-07277 | AMAT 0190-35489 | AMAT 0190-28651 |
| AMAT 0190-07312 | AMAT 0190-07848 | AMAT 0190-28658 |
| AMAT 0190-07328 | AMAT 0190-07905 | AMAT 0190-28683 |
| AMAT 0190-07351 | AMAT 0190-07907 | AMAT 0190-28822 |
| AMAT 0190-07371 | AMAT 0190-07911 | AMAT 0190-28859 |
The content is from Ruichang Mingsheng Automation Equipment Co., LTD
Contact: +86 15270269218
